[ Date Prev][ Date Next][ Thread Prev][ Thread Next][ Date Index][ Thread Index]
Re: Re: [coldfire-gnu-discuss] Connecting to a Coldfire target using P&E USB Coldfire Multilink.
- To: Claude Sylvain <csylvain@xxxxxxxxxxxxxxxxxxxx>
- Subject: Re: Re: [coldfire-gnu-discuss] Connecting to a Coldfire target using P&E USB Coldfire Multilink.
- From: Carlos O'Donell <carlos@xxxxxxxxxxxxxxxx>
- Date: Mon, 11 Dec 2006 13:15:27 -0500
On Mon, Dec 11, 2006 at 11:47:35AM -0500, Claude Sylvain wrote:
> - From that point, I compiled a little project and connected to the
> target using GDB.
> From GDB, when executing a "load" command, there was error(s), and I
> have to make many "load" to finally have the command work correctly.
> I tryed also to exit GDB, re-execute GDB. Also disconnect/re-connect the
> USB Multilink without success.
>
> - After I have done a Poweroff and Poweron (the following day), all
> was working like a charm !
Please read the section "Installing P&E Drivers" of the "Getting
Started" guide. It covers the correct sequence to try if you have
problems with the P&E drivers.
Cheers,
Carlos.
--
Carlos O'Donell
CodeSourcery
carlos@xxxxxxxxxxxxxxxx
(650) 331-3385 x716
|
