Re: [qmtest] qmtest targets: I'm missing something...

[Stefan Seefeld <seefeld@xxxxxxxxxxxx>]

J.T. Conklin wrote:
> Hi Folks,
> 
> I've been reading the documentation, but I seem to be missing
> something obvious wrt. qmtest's targets.
> 
> I understand that with "qmtest create-target" you can create 
> a new qmtest target or target group with a set of attributes.
> By default database of targets is stored in QMTest/Targets.

(This is 'QMTest/targets' with a lowercase 't'. At least on
 platforms where it matters.)

> I understand that "qmtest run" can select a specific target
> database with the -T option, but it defaults to QMTest/Targets.
> 
> What I don't understand is how you run a test suite against a
> target or target group within the target database.

I'm not sure I understand the question. Targets are a means to
run tests in parallel. However, when assigning multiple hosts
to targets, not all hosts may be suitably equipped to run all
test instances, so the test-specific 'taret_group' attribute
contains a pattern against which indidual targets are matched.

May be you are trying to use targets for something else, such
as run on multiple platforms ?

Regards,
		Stefan

-- 

      ...ich hab' noch einen Koffer in Berlin...